I believe we should all know that in the use of many machines and equipment in the process, will inevitably appear some small faults, and automatic locking screw machine can not be an exception. Sometimes, when we use the dynamic locking screw machine, there may be a failure to open the machine, screws can not be sucked, screws floating high, leakage of locking ...... and other relatively common problems. So when the automatic locking screw machine appears these common problems, how to solve it? Here we will share with you the common problems of automatic locking screw machine and solutions:

Frequently asked questions 1: automatic locking screw machine can not open the machine

Solutions:

1. the power connector is loose

2. 220AC is normal power supply

3. the power switch may have forgotten to open the

4. the power cord is not damaged amount, the fuse has not blown!

Frequently asked questions 2: automatic locking screw machine screws lock slippery teeth

Solutions:

1. check whether the batch torque is suitable for locking the attached torque range, the use of torque meter to re-test the batch torque

2. check whether the product screw standard

Frequently Asked Questions 3: Screws can not be sucked (suck type automatic locking screw machine)

Solutions:

1. test the screw feeder has no screws, hand screws are working properly

2. whether the vacuum exists, or vacuum filter blockage

3. the screw feeder signal line is not off

Frequently Asked Questions 4: Automatic locking screw machine product screws floating high

Solutions:

1. the detection program in the steps set in the locking height whether the actual locking position of the screws, locking with the speed parameter withdrawal is correct

2. check whether the batch head torque is small

Frequently asked questions 5: product screw machine leakage lock (suck type automatic locking screw machine)

Solutions:

1. check whether the vacuum is weakened, open the Y-axis vacuum cover, remove the vacuum generator for processing

2. check whether the screw sucking position offset, into the system parameters to reset the sucking position

3. Whether the batch head is installed, whether the fixed electric batch screws are loose

Frequently Asked Questions 6: The feeder is always alarmed (suction type automatic screw locking machine)

Solution:

1. feeder signal line is normal access

2. feeder turntable size and diameter is not the right choice

3. whether the screws are stuck, screws are not used up